3D Printer Controller Board Shield For Ramps 1.4 Reprap Prusa Mendel Arduino

RAMPS 1.4 RepRap 3D Printer Electronics Controller for Arduino Prusa i3 Mendel

The RAMPS 1.4 board to fits the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform with plenty room for expansion. A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Specifications: 

• It has right-angle coordinate robot and provisions of extruder.
• Extended to the 2 control and other accessories.
• The 3 heater / fan output and 3 thermistor circuit MOSFET.
• Fusion 5A additional safety and protection
• Heating bed control 11A fuse additional
• For 5 Pololu stepper drive plate
• Pololu plate dynatron, so they can be easily replaced or removed for future design.
• The 8.I2C and SPI pins left for future expansion.
• Of all MOSFET hooked into PWM pin is universal.
• Servo type connector for connecting to a terminal block, a motor and a light emitting diode. These connectors gold-plated, rated current is 3A, very compact.
• The 11.SD card add – is now available from Kliment – Sdramps
• 12.LED indicates the heater output
• The 13 option 2 motors are connected to the Z Prusa Mendel

• Brand new and high quality.
• Fully assembled & tested, no soldering required.
• It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
• The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion.
• A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
• Size: 11.5cm x 6cm / approx. 4.5in x 2.4in.

Package Included:

• 1 x 3D Printer Controller for RAMPS 1.4