40-50W CO2 High Voltage Flyback Transformer for MYJG-40/50 PSU Laser Power Supply
- The 40-50W Flyback Transformer is Used in the Co2 Laser Power Supply MYJG-40/50.
- The 40-50W Laser Power Supply needs 1 Piece Flyback Transformer.
- Please Check the Install Schematic Diagram to make sure it fits your Power Supply.
- The Screw is for install fixed on the Laser Power Supply Board.
- Replace DIY part for CO2 Laser engraving cutting machine
- If the Co2 laser engraving machine laser power is weak, and it can’t cut through any materials. Then adjust the laser power to the maximum value. At the same time, please check the machine’s Current. If the Current is still less than 8 mA. Then you need to replace a new flyback transformer for the laser power supply.