Cloned PanelDue Touch Screen Controller Board
Compatible with 4.3″, 5″, and 7″ Screens for DuetWifi
Overview:
The PanelDue is a versatile color touchscreen controller designed for use with the Duet and other 3D printing electronics. It supports three screen sizes: 4.3″, 5″, and 7″, with resolutions of 480×272 for 4.3″ displays and 800×480 for 5″ and 7″ displays.
Key Features:
- Screen Compatibility: 4.3″, 5″, and 7″ displays
- Resolution: 480×272 (4.3-inch), 800×480 (5- and 7-inch)
- Power: 5V power from the host 3D printer controller
- Connectivity: 2-wire async serial interface with 3.3V signal level (5V tolerant input)
- External SD Card: Connections are available via a 10-way ribbon cable connector on version 2.0 boards
- Cable: 4-wire cable for serial and power connections
Additional Information:
- The control board without a screen is available, but a compatible SSD1963 LCD panel (4.3”, 5”, or 7”) is required. To set it up, follow the instructions on David Crocker’s PanelDue blog.
- This board is based on the DuetWifi by Think3dPrint3d and Esher3d, but it is a reproduction and not endorsed or supported by these entities. For original DuetWifi information, visit duet3d.com.
Package Includes:
- 1x Control board (screen not included, not original)
- 1x Connect cable
The PanelDue is a color touchscreen controller for the Duet and other 3d printing electronics that support it.
The control board and firmware support three screen sizes: 4.3″, 5″, and 7″, at two resolutions: 480×272 pixels (4.3-inch displays) or 800×480 pixels (5—and 7-inch displays). Note that the lower resolution of the 4.3” display means that it cannot display as much information on the screen—for example, a maximum of 4 extruders, as shown in the picture.
5V power from the host 3D printer controller.
2-wire async serial interface with 3.3V signal level (5V tolerant input).
On version 2.0 PanelDue boards, a 10-way ribbon cable connector allows connections to the external SD card socket included on most compatible displays.
4-wire cable to connect the PanelDue to your controller board for the serial and power connections.
The control board without a screen is also available; however, a 4.3”, 5”, or 7” SSD1963 LCD panel is required, and the instructions on David Crocker’s PanelDue blog must be followed.
Based on the DuetWifi by Think3dPrint3d and Esher3d, see www.duet3d.com for the original DuetWifi information. This reproduction/modification is not endorsed or supported by Think3dPrint3d or Escher3d”.
Package including:
1pc control board (without the screen and not original)
1pc connect cable
There are no reviews yet.