| Customized high quality connection, using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug. | |
| Product Details | |
| 1. Red line connecting VCC (ramps of +) 2. Connect the black wire GND (ramps of -) 3. Green Line connection SIGNAL (ramps in s) Tips: Under normal circumstances, the system must be configured to at least three mechanical switches. Pros: Easy to install, the more common styles. | |
| What’s in the Box | |
| 1 x mechanical switch 1 x Cable 3-pin 70CM | |
Circuit boards and controllers, CNC
End Stop Mechanical Limit Switch W/ LED + wire for 3D Printers RepRap
Availability:
Out of stock
Customized high quality connection, using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.
$1.69
Out of stock
| Weight | 0.02 lbs |
|---|---|
| Dimensions | 2 × 1 × 0.5 in |
Based on 0 reviews
Be the first to review “End Stop Mechanical Limit Switch W/ LED + wire for 3D Printers RepRap”
You must be logged in to post a review.
Related products
- FDM 3D Printer, CNC, Arduino, Arduino Boards
CNC Shield V3 Expansion Board +4PCS StepStick A4988 Stepper For Arduino DIY – R
FDM 3D Printer, CNC, Arduino, Arduino BoardsCNC Shield V3 Expansion Board +4PCS StepStick A4988 Stepper For Arduino DIY – R
CNC Shield V3 Expansion Board +4PCS StepStick A4988 Stepper For Arduino
This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.SKU: 319315 - FDM 3D Printer, 3D Printer Timing Belt pulley sets, Deals and Specials
3D Printer GT2 Timing Belt 10 meters, 2mm Pitch, 6mm Width. Pully 4 x 5mm bore, 7mm max belt width
FDM 3D Printer, 3D Printer Timing Belt pulley sets, Deals and Specials3D Printer GT2 Timing Belt 10 meters, 2mm Pitch, 6mm Width. Pully 4 x 5mm bore, 7mm max belt width
Pulleys:
4 x 5mm bore, 7mm max belt width, designed for GT2 2mm Pitch belt8 x set screws2mm allen keyBelt:10 Meters of GT2 Timing belt2mm pitch6mm width.SKU: 264
There are no reviews yet.