,

Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W

CloudRay
Availability:

Out of stock


$179.99

Out of stock

Features:

  • Good compatibility: it can be applicable to 80-100W Laser Tube manufactured by various factories.
  • Quick response speed and effect, high performance, large cutting power, it also can prolong laser tube service life.
  • Easy control: the start and stop of the laser can be easily controlled by TTL level.
  • The power supply has output open circuit protection, TTL signal indication, water through signal indication and laser output indication. And the Button to test output laser manually.
  • Application: Sculpture and cut acrylic, fabric, double color sheet, and rubber, etc.
  • Zero-current half-bridge soft-switching circuit. High efficiency and fast response. Match various manufacturers of laser tubes.
  • Simple Port Control, TL level signals can control the laser start/stop.
  • Protection switch is to check the outside water, ventilation, etc.
  • Laser Power Adjustment: input 0V to 5V analog signal, can also input PWM signal.
  • Open Circuit Protection Function: avoid the damage to laser power supply due to laser tube burst.
  • Factory Aging Test: 1. Each power supply will go through 60℃ and 12 hours aging test under full load. 2. 500 times 7 seconds Start / Stop test.

Connection:

1. Laser Tube connection: (Refer to Power supply and laser Device’s connection Diagram) High voltage terminal of MYJG-100 power supply should be connected to the positive pole of CO2 laser device. Current circuit of the power supply shall be connected to the negative pole (laser output terminal) of a laser device, through an ampere meter or directly.

2. Connection of control signal( Refer to Power supply and control board’s connection Diagram) The control signal shall be reliably connected to control terminal of the power supply MYJG-100, after connecting the DAC output signal and TTL signal of an external computer with the power supply, the laser device shall work as expected. If the laser lamp cannot work properly, should check the control signal whether correct or not(include check the voltage specification and logic),if use PWM control as power control, make sure f≥20KHz, Amplitude (peak value) ≤5V, Check and protection switch WP connection is correct at the same time.

3.  Others: A group of protection switches is also reserved for detection of water switch, fan switch,open-enclosure protection and so on.  

 

Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100WCloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W Cloudray 100W CO2 Laser Power Supply 110V for CO2 Laser Engraver MYJG-100W

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
M
M.

Super fast shipping. Easy install. Good solid unit.

L
L.

Super fast shipping from USA. Was exactly as described. Will return for more parts as needed