3D printer kit RAMPS 1.4 + Mega 2560 + 5pcs A4988 + LCD 2004 RepRap Prusa i3

Availability:

In stock


  • 3D Printer Controller RAMPS 1.4
  • Arduino Mega 2560 R3 control board: 
  • RAMPS1.4:
  • A4988 stepper motor driver board:
  • 3D 2004 LCD control panel:

$29.99

In stock

Return period: 90 Days

Purchase this product now and earn 27 Points!

3D Printer Controller RAMPS 1.4

The RepRap Arduino-compatible MEGA Pololu Shield, or RAMPS for short. Designed to fit all the electronics needed for a RepRap in one small low cost package.

RAMPS interfaces an Arduino-compatible Mega with the powerful Arduino-compatible MEGA platform with room for expansion.

Efficient modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion. Also a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Arduino Mega 2560 R3 control board: This is a 3d printer brain responsible for controlling the entire printer to perform certain actions, such as print specific documents;
RAMPS1.4: This is the main board above the expansion board, there it is in order to better connect with other hardware and control, play the role of a bridge;
A4988 stepper motor driver board: This is used to connect the stepper motor control board in order to achieve control of the stepper motor and extruder to achieve XYZ movement;
3D 2004 LCD control panel: used to display, to achieve the 3D printer’s control.

Version 1.4 uses surface mount capacitors and resistors to further cover edge issue cases.

  • Condition: New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller’s listing for full details.
  • Type: 3D Printer Controller Kit
  • Model:Arduino Mega2560, RAMPS 1.4, A4988
  • Microcontroller: ATmega2560
  • Operating Voltage: 5V
  • Input Voltage (recommended): 7-12V
  • Input Voltage (limits): 6-20V
  • Digital I/O Pins: 54 (of which 14 provide PWM output)
  • Analog Input Pins: 16
  • DC Current per I/O Pin: 40 mA
  • DC Current for 3.3V Pin: 50 mA
  • Clock Speed: 16 MHz
  • LCD: LCD2004
  • Category: 3D Printer

It is simple to wire up the RAMPS. Just add the extruder heating coil wire to D10, the thermistor to the two T0 pins on middle right right, and wire up the steppers and endstops. From left to right, wire all of the stepper motor’s wires as red, blue, green, and black or red, green, yellow, blue into the pins next to the Pololus. When you connect the wires to the endstops (if you are using 3 endstops, plug them into the MIN (-) slots), make sure you match the labels.

Shipping list: 
1.3D 2004LCD control board (wiring and adapters) * 1
2.3D printer control panel RAMPS 1.4 * 1
3.Arduino 2560 R3 development board (send USB cable) * 1
The A4988 stepper motor driver with heat sink * 5

Share your thoughts!

Let us know what you think...

What others are saying

There are no contributions yet.

×

Continue as a Guest

Don't have an account? Sign Up