Boards and controllers, LCD's for 3D Printers

Cloned PanelDue Touch Screen Controller Board Compatible 4.3″ 5″ 7″Screen For Connect DuetWifi Advanced 32 Bit Electronics


In stock





Return period: 90 Days

Earn up to 20 Points.

Add to Wishlist
Add to Wishlist

Cloned PanelDue Touch Screen Controller Board Compatible 4.3″ 5″ 7″ Screen For Connect DuetWifi Advanced 32 Bit Electronics 

The PanelDue is a color touch screen controller for the Duet and other 3d printing electronics that support it.
The control board and firmware support 3 screen sizes: 4.3″, 5″ and 7″, at two resolutions: 480×272 (4.3-inch displays) or 800×480 pixels (5- and 7-inch displays). Note that the lower resolution of the 4.3” display means that it cannot display as much information on the screen – for example, a maximum of 4 extruders, as shown in the picture.
5V power from the host 3D printer controller.
2-wire async serial interface with 3.3V signal level (5V tolerant input).
Connections to the external SD card socket that is included on most compatible displays is available via a 10-way ribbon cable connector on version 2.0 PanelDue boards.
4-wire cable to connect the PanelDue to your controller board for the serial and power connections.
The control board without a screen is also available however a 4.3”, 5” or 7” SSD1963 LCD panel is required and the instructions on David Crocker’s PanelDue blog must be followed.
Based on the DuetWifi by Think3dPrint3d and Esher3d, see for the original DuetWifi information. This reproduction/modification is not endorsed or supported in any way by Think3dPrint3d or Escher3d”.
Package including:
1pc control board (without the screen and not  original)
1pc connect cable