3D Printer Parts TMC5160 V1.2 SPI Stepper Motor Driver S5160 Step stick Mute Driver Flying Wire For F6 Board VS TMC2130 V1.2
Hardware compatible with Step Stick and Pololu A4988 Stepper Motor Drivers
stepper motor driver (chopper drive / constant current drive)
Components on the bottom PCB side for better heat emission
Automatic standby current reduction
microPlyer – micro step interpolator for increased smoothness of micro stepping
stealth Chop – for quiet operation and smooth motion
spread Cycle – highly dynamic motor control chopper
Drive capability up to 3A (RMS) continuous coil current
Step/Dir interface with up to 256 micro steps
SPI interface for configuration
Motor supply voltage: 10…35V
Logic supply voltage: 3.3…5V
RSense: 0.075 Ohm
What is the difference between TMC5160 and TMC2130 Silent StepSticks?
TMC5160 SilentStepSticks have no standalone mode and no internal pull-up resistor on the CS/SS pin. (SPI configuration is always needed)
The direction is not inverted on TMC5160 Silent StepSticks.
The software configuration is mostly the same, except the motor current calculation is different.
TMC5160 Silent Step Sticks have an improved stealth Chop mode (stealth Chop2) and a higher motor current rating.
On TMC5160 Silen tStep Stick v1.3 the CLK pin has to be connected to GND.
Extra features of TMC2130:
SPI configuration interface (up to 4MHz)
up to 256 native microsteps (without interpolation)
coolStep – current control for energy savings
stallGuard2 – sensorless motor load detection
dcStep – load dependent speed control
Automatic stealth Chop and spread Cycle switch over depending on the velocity
This version is not required to be wired. It is used on the F6 board. We will provide the wiring version for other boards. Please pay attention to our shop or our facebook.