No products in the cart.
-33%
Ledge Hotend parts, Lerdge accessories, Power modules, Wholesale
2PCS Automatic Leveling Module Film Pressure Probe Type Auto-Leveling Sensor (Suitable for Makerbot nozzles)
Availability:
In stock
$9.99 $14.99
In stock
2pcs 3D Printer Part Automatic Leveling Module Film Pressure Probe Type Auto-leveling Sensor For V6 MK8 Nozzles
Features:
1. Easy to be used. Can be applied to different types of 3D printers. The default trigger distance is 0.1mm.
2. High precision, leveling repeatability can be ± 0.05mm.
3. The average service life of the module is more than 500,000 times.
4. Compatible with almost all the 3D printer motherboards in the current market
5. Good anti-interference ability, will not be affected by the platform material, ambient light, ambient temperature and humidity, etc. .
Note: Do not use the leveling sensor when the nozzle temperature is higher than 45 degrees!!!
| Weight | .1 lbs |
|---|---|
| Dimensions | 4 × 4 × 1 in |
Related products
- Step down power modules, Wholesale, Power Modules
10PCS DC-DC Buck step down Converter 6-24V 12V/24V to 5V 3A CAR USB Charger Module
Step down power modules, Wholesale, Power Modules10PCS DC-DC Buck step down Converter 6-24V 12V/24V to 5V 3A CAR USB Charger Module
- New design, 3 solid state ceramic capacitors(MCC), more safe and low ripple
- The max output current 3A, long time use 2.1A, enough use
- Synchronous rectification, High efficiency, 6.5V to 5V 0.7A can up to 97.5%, 12V to 5V 1A can up to 94%
- With output overvoltage protection. There is 1.5A fuse, output 5V have 300W TVS tube protect your USB device
- Package Including: 1 x USB DC-DC Step Down Module
SKU: 310726 - Sensor Modules, LDR Light Dependent Resistor, Arduino Accessories, Wholesale, LDR Light Dependent Resistor
200PCS Photoresistor LDR CDS 5mm Light-Dependent Resistor Sensor GL5516 Arduino
Sensor Modules, LDR Light Dependent Resistor, Arduino Accessories, Wholesale, LDR Light Dependent Resistor200PCS Photoresistor LDR CDS 5mm Light-Dependent Resistor Sensor GL5516 Arduino
Light-dependent resistors or photoresistors are a staple of electronics. If you need a way to sense the level of ambient light then there is no easier way to do it. As the light on the sensor increases then the resistance across the two leads decreases. If you have a rear view mirror that darkens when its hit buy headlights you can check in the little hole on face of the mirror and you’ll see those wavy lines of photoresistor!
SKU: 944 - Power modules
3D Printer Heated Bed Power Module Hotbed MOSFET Expansion Module Inc 2pin Lead
Power module for controlling 3D printer heated bed, it is also can be used to drive other non-inductive loads. If you plan to use silicone heater of large area heated bed, you most likely will overcome limitations for the current, that can handle your current 3d printer electronics. This control board will handle high current without even getting warm. Oversize MOSFET and overall very robust PCB design will allow for trouble free operation without active cooling.
SKU: 4373
