End Stop Mechanical Limit Switch W/ LED + wire for 3D Printers RepRap

$1.69

Customized high quality connection, using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.

Out of stock

Description

Customized high quality connection, using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.
Product Details
1. Red line connecting VCC (ramps of +)
2. Connect the black wire GND (ramps of -)
3. Green Line connection SIGNAL (ramps in s)
Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.
Pros: Easy to install, the more common styles.
What’s in the Box
1 x mechanical switch
1 x Cable 3-pin 70CM

Additional information

Weight0.02 lbs
Dimensions2 × 1 × 0.5 in

Reviews

There are no reviews yet.

Be the first to review “End Stop Mechanical Limit Switch W/ LED + wire for 3D Printers RepRap”